Software that we use is Ufs Micro
Steps were as follows:
Open Software KZF from SarasSoft (No need to wear Sedbx)
After connect, select the model HPnya (K300)
Make sure the computer is already connected HP / KZF well.
Must have the know how how? If not, plug the cable HP with flash and press GO. If you are already connected will have any posts stating that HP has been connected properly. If you are still not connected, press GO and loose pairs of batteries, until well connected. (Flasing HP Sony Ericsson have to use batteries and make sure the battery is fully charged at least half, so that when the boot is not compromised.
Then enter its Flash File (X_K300_R2BA010_GenericAPAC1)
On K300 there are only 2 pieces of the file. First and second MCU File File Cust / Fs
After entering the file, press Flash MCU
Once the process is complete Gantian press Flash Cu / fs
After all runs smoothly and normally. Disconect, unplug the power cord, unplug the battery, the battery and try to turn the tide again, praying that HP back to normal.
Success for you.
