2. Desktop shortcut will be created.
3. Install the USB Driver (C:\Program Files\Nokia\Phoenix\USB_Driver)
Note: For initial setup, USB driver is needed for each box connected to PC.
4. Files will go to (C:\Program Files\Nokia\Phoenix\Products) after installing the DCT4
Original Flash Files. DCT3 Flash Files will go to (C:\wintesla)
Creating Ini files for all models:
Ini files should be created for all models before using this software. It will decrease your time when
working with large number of phones. First step is choosing phone model and needed MCU and PPM.
This is related to flash part, in UI Options, you choose what you need (when you flash the DCT3 don’t
forget FAID), click to “create Ini button”. After this step, you can start using UFS Nokia software.
DCT3 phones:
SW upgrade:
Just click “start” and all will be done automatically, if you’ve created Ini file before.
Note
If you need to flash only MCU, or PPM, or PMM (eeprom) just remove stick “use Ini file
settings” and choose needed file/s for flash, click “start” button and that’s all.
Unlock:
Stick “Init Simlocks” on Ui options tab, and click UI Settings on main menu.
Or double click the “Init Simlocks”
Additional functions
Rebuild IMEI - use it when you need to repair IMEI in phone.
Read flash - you can read flash from phone and make your own files using “convert files”
option.
Erase flash - use it to erase flash, it can help you to rebuild IMEI.
DCT4/WD2 Phones:
For main functions, use same procedure as with DCT3 phones. SW upgrade, unlock, and resets
are done in the same way.
For special functions related to DCT4 /WD2, explains below:
User Setting items:
You can save and write backup phone book, ring tones , graphic logos and UI settings.
(not all models supported)
Read UEM:
With this function, you can read *.ask file, needed to repair phone’s IMEI after flash IC
changing.
Write UEM -SL
This function is used for writing *.rpl files. You can rebuild/change IMEI using proper *.rpl
files.
Erase flash:
Use only when you’ve replaced flash chips, so you can re-program it fully.
Format USER area:
This function is used only with WD2 phones, and you can use it if phones had problems, or if
you need to make it “blank” .
Tips:
Flashing dead phones:
Remove stick “auto detect product”, choose model you want to flash, and needed files. After
these steps, click “start” button.
CP uploading:
You can manually choose CP (content package) using same procedure as for flashing. After
you set proper CP, click start button and software will do the rest.
Write PM:
Use this function to write PMM (permanent mode memory) into your phone. You need to do
this when you replace flash chip, or if PMM area is damaged by any cause.
